Day 25 - Sanding and Filleting

After taking Friday off, I got to work Saturday morning on finishing up on placing a fillet of resin on the front half of the boat. Also cleaned up some of the resin at the stern.

While that was curing, I began sanding the inside of the boat, and all the places where the resin had dried along the panel seams. It's much easier to sand on the outside of the boat. Have burned through about 6 sheets of sand paper - and that's after cutting each sheet into 4 sections. Lots of sanding.

I did put the hull identification number on the inside of the boat. This is a coast guard required number that has to be incorporated into the boat - like a vehicle identification number.

Sunday - more sanding. May do some work with the resin. My fingers are tired.